How to Set Your Audi Memory Seat Position: A Beginner’s Guide
This feature allows you to save your perfect driving position—including the seat, side mirrors, and sometimes the steering wheel—so you can recall it with a single press.
Step-by-Step Tutorial
Follow these easy steps to program your preferred setting into one of the memory buttons (usually labeled 1 and 2).
Step 1: Park Your Vehicle
- Ensure your Audi is parked safely.
- The ignition should typically be on or the car in accessory mode (this can vary, so if one doesn’t work, try the other).
Step 2: Adjust Everything to Your Perfect Position
Use the electric controls, usually located on the side of the seat or the door panel, to adjust the following:
- Seat Position: Move the seat forward/backward, up/down, and adjust the seat cushion tilt.
- Backrest Angle: Adjust the angle of the backrest for comfort.
- Lumbar Support: Adjust the lower back support (if equipped).
- Side Mirrors: Use the mirror selector switch (usually on the driver’s door) to adjust both the left and right exterior mirrors.
- Steering Wheel: If your Audi has a power-adjustable steering column, adjust its position (up/down and in/out).
💡 Pro Tip: This is the most important step! Take your time to get the position just right for maximum comfort and control.
Step 3: Initiate the Memory Save
Locate the memory control buttons on the driver’s door panel. You will typically see a “SET” button and one or more numbered buttons (usually “1” and “2”).
- Press the “SET” button once.
- A light (often red) will illuminate on the “SET” button. This indicates the system is ready to record a setting.
Step 4: Save Your Position
- Within a few seconds of pressing “SET,” press the desired numbered button (“1” or “2”) until you hear a confirmation tone (a beep or chime).
- Release the button once you hear the tone.
Congratulations! Your custom seat, mirror, and steering wheel settings are now saved to that number.
How to Recall Your Saved Position
If someone else drives your car and moves the seat, here is how you return to your stored position:
| Scenario | Action |
| Door is OPEN and/or Ignition is OFF | Press the desired numbered button (1 or 2) once briefly. The seat will automatically move to the saved position. |
| Door is CLOSED and/or Ignition is ON | You must press and hold the desired numbered button (1 or 2) until the seat and mirrors are fully adjusted. This is a safety feature. |
🔑 Key-Based Memory (Advanced Tip)
Many modern Audis can automatically link your saved seat position to your specific key fob or user profile.
- To Check: After setting your position (Steps 1-4), exit the vehicle, lock it with your key, and then unlock and re-enter. The car should automatically load your profile and adjust the seat to your saved position before you even press a button.
- If you share the car, make sure the second driver follows this entire tutorial using their own key fob to save their settings to the other memory button (e.g., “2”).
Next up: Learn how to activate your Audi’s keyless entry and hands-free trunk feature — so you can unlock and load up without touching a single button.
